Display
09.95
Siemens AG 2001 All Rights Reserved 6FC5197jAA50 9–43
SINUMERIK 840C (IA)
Note The displayed measurement results can be stored as a file on the MMC by selecting
softkey File functions.
Data output of Data can be output on an external PC via the V24 interface and
circularity test by means of commands in the Services menu. The extensions for Services
measurement results required for this purpose are listed in the requirements to other areas. Data can
therefore be output in PC format with the aid of the PC-IN program. Within this
program, it is possible to re-convert the data back to the original ASCII format
with software version 3.0 and higher.
Note Measurement results can also be written to a file using the hardcopy function and
output by means of Services functions.
SW 5
You can switch to graphic representation of the contour with this softkey.
Fig. 9.19
Explanation The contour is shown without any distortion if the value 0 is entered in the field
Resolution. If suitable radius and feedrate values are entered, other contours
can also be displayed.
Radius and feedrate represent the input parameters required for setting the mea-
suring duration and the radius is used to define the form of graphic representa-
tion.
Note Storage and output of the measuring results are the same as described for the
circularity test display in Section 9.5.2.
9 Drive Servo Start-Up Application (as from SW 3)
9.5.2 Circularity test (option SW 4)