Intel SRCU31 user manual Quick Start Instructions, Nwconfig, 5.Component Installation

Quick Start Instructions

5.It will eventually load a Welcome screen, asking you to verify the startup directory (C:\NWSERVER). Hit Alt F10 to exit the installation. At the console, type Down. The installation exits to the boot drive prompt.

6.Insert the SRCU31 NetWare installation diskette created in step 1. into the A: drive. If your boot drive is C:, then run NWUPDATE.BAT. If your boot drive is other than C:, then create an NWUPDATE subdirectory and copy all the files from A:\DRIVERS into the NWUPDATE subdirectory.

7.Remove the diskette from the A: drive and reboot the server. After booting you will be asked to accept the license agreement. Do so and then select Continue with Existing Partition. You are now ready to install NetWare 5 on the Intel Integrated RAID volume.

8.Continue with the NetWare installation as normal by following the screen prompts. Select the Block Storage OSM when prompted.

9.Reboot the server and install Service Pack 4 or higher. Once the server installation is completed, reboot the server.

10.To install the Intel Integrated RAID software (run the Intel Integrated RAID setup) run

NWCONFIG.

11.Select Product Options, then Install product not listed. It will tell you that it is going to scan the A: drive for installation scripts. Ensure the SRCU31 NetWare Installation diskette is in the floppy drive, hit Enter to continue.

12.A screen prompt will ask which components (see below) you wish to install. Select the following components and hit F10 to continue. See Figure 1-5.

BKSTROSM.HAM

HTTP and Winsock Services

RAID Management Agents

Figure 1-5. Component Installation

The appropriate files are copied and the AUTOEXEC.NCF and STARTUP.NCF files are modified as necessary.

13. After the installation is complete, reboot the server.

1-12 Intel® Server RAID Controller U3-1 User’s Manual Rev 1.0