Intel SRCU31 user manual 2.5.9.1In this Section, 2.5.9.2RAID Requirements for UnixWare

Advanced Installation Steps

2.5.9Setup and Installation for UnixWare*

2.5.9.1In this Section

•RAID Requirements for UnixWare

•Installing UnixWare on a RAID Volume

•Installing UnixWare on a Pass-through Device or another Storage Device

•Install Intel® Server RAID Controller U3-1 on an Existing UnixWare Server

•Uninstalling Intel® Server RAID Controller U3-1 from UnixWare

2.5.9.2RAID Requirements for UnixWare

When installing SRCU31 for UnixWare 7.1, note the following system requirements.

RAID Hardware Requirements

•Server with CD-ROM Drive not attached to Intel® Server RAID Controller U3-1

•One available PCI slot (64bit, 33MHz recommended)

•Monitor display resolution of 800 x 600 or higher (recommended)

•Intel® Server RAID Controller U3-1 Adapter Card

•PCI 2.2 Compliant System BIOS

•Memory: 3.3v, 168-pin gold-plated, unbuffered PC100, ECC, SDRAM single or double row, DIMM modules that are of 32MB, 64MB, 128MB capacities (see supported parts at http:// support.intel.com/support/motherboards/server/srcu31)

RAID Software Requirements

•SRCU31 CD-ROM

•Hard disk space: minimum 20 MB

•UnixWare Installation Diskette (to create this diskette, see Chapter 3, “Exploring the Utilities”)

•SCO UnixWare 7.1 software with Netscape 4.08 or greater (included with SCO)†

†Not supplied with SRCU31.

Have all required system hardware and software components available before proceeding with the setup and installation.

Warning: Do not install OSM(s) downloaded from OS vendor websites. The OSMs provided on the Intel Server RAID Controller U3-1 CD-ROM are a later version than the OSMs currently provided by OS vendors. Using OSMs other than those provided on the SRCU31 CD-ROM may cause unpredictable results.

2-62 Intel® Server RAID Controller U3-1 User’s Manual Rev 1.0