Intel SRCU31 user manual Advanced Installation Steps

Advanced Installation Steps

c.After the NT installation is complete, install the following components and software:

—Microsoft Windows NT 4.0 Service Pack 5 or greater

—Microsoft Internet Explorer 4.00 or greater

5.If your browser uses a proxy server, then configure your browser using the procedure in Section B.6, “Browser Configuration During Initial Installation” on page B-5and return to this procedure. If you have not configured your browser to use a proxy server, then go to step 6.

6.Install the SRCU31 software (run the SRCU31 setup).

Note: You must have administrative level permissions to install SRCU31 software. This procedure assumes that the SRCU31 hardware and Windows NT server are installed and operational in your system.

a.Insert the SRCU31 CD-ROM in the CD-ROM drive. If the Software Installation Main Menu does not appear, then run the setup.exe file that resides at:

<CD-ROM root>\os_setup\winnt\setup.exe on the CD-ROM.

b.Click on the Setup button. See Figure 2-20. Follow the on-screen prompts to complete installation.

The three components in the window in Figure 2-21are preselected. Add the remote storage console component by clicking on the remote storage console box.

Note: The DMI and SNMP components are not selected by default. Refer to section Section 4.2, Intel® Integrated RAID Software Component Installation for information on DMI and SNMP installation.

A progress bar appears that measures the progress of the SRCU31 setup. When this screen completes, you have completed the SRCU31 setup.

Note: Refer to section “Intel® Integrated RAID Software Component Installation” on page 4-3of the “Using the Storage Console” chapter for information on HP Openview and RAID Monitor.

7.See Chapter 4, Section 4.3, “Configuring RAID Volumes Using the Intel® Integrated RAID Storage Console” on page 4-12to customize your RAID volumes using Storage Console.

2-28 Intel® Server RAID Controller U3-1 User’s Manual Rev 1.0