
Exploring the Utilities
b. Power off all system components and disconnect their power cords.
Warning: Shock hazards may be present inside the unit in which this card is being installed. Disconnect all power cords to the unit before removal of any covers. Follow the warnings noted in your computers user or service manual before installing this board. ONLY after all the covers are reinstalled should you reattach the power cords and power up the unit for the software installation and use.
c.Remove the cover from the system to gain access to the PCI slots.
d.Remove the SRCU31 adapter card from your system.
e.On Jumper block J7 D1 (bottom right corner of card) move jumper 1 from position
f.Replace the cover, reconnect all power cords and power up the system.
Figure 3-6. Jumper Settings (View of Bottom Right Corner of Card)
| Flash Mode | Run Mode | |||||||||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| (normal) | |||||||
1 - 2 |
|
|
|
|
|
|
|
|
|
|
| 2 - 3 |
|
|
| ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
3. Flash the Firmware
To Flash the firmware using the
Note: To Flash the firmware using a diskette, contact Technical Support.
4. Reset the Jumpers to Run mode
Warning: Shock hazards may be present inside the unit in which this card is being installed. Disconnect all power cords to the unit before removal of any covers. Follow the warnings noted in your computer user or service manual before installing this board. ONLY after all the covers are reinstalled should you reattach the power cords and power up the unit for the software installation and use.
a.Power off all system components and disconnect their power cords.
b.Remove the system cover.
c.Remove the SRCU31 adapter card from your system.
d.On Jumper block J7 D1 move jumper from position
e.Replace the cover, reconnect all power cords and power up the system.
Intel® Server RAID Controller |