![](/images/new-backgrounds/1176086/176086181x1.webp)
Advanced Installation Steps
be unable to retrieve its copy of this (and other) file(s). Depending on the particular service being requested, fulfilling the request may take a long time, or may fail completely.
If you do not plan on using NIS, defer installation of NIS during the installation by pressing <F8> on the NIS configuration screen. If you decide at a later time to install NIS, you can do so using the pkgadd(1) command. Go to step 6.
5.Insert UnixWare 7.1 Volume: 1 of 2 diskette and reboot. Install the OS using the install instruction provided in UnixWare 7 Installation Guide manual. UnixWare will prompt you to install Host Bus Adapter diskette. At that time insert the Unix Installation diskette when prompted. To create a UnixWare Installation diskette see the “Make Diskettes” section in Chapter 3, “Exploring the Utilities”.
Note: During the installation of UnixWare, you will be prompted to install the Network Information Services (NIS) package. By default the installation will configure your system as an NIS client. See your system administrator for configuration of the NIS services.
After the installation, files such as /etc/inet/inetd.conf are supposed to be distributed to the client via NIS. If, however, you don't have a master NIS server on the network, the client will be unable to retrieve its copy of this (and other) file(s). Depending on the particular service being requested, fulfilling the request may take a long time, or may fail completely.
If you do not plan on using NIS, defer installation of NIS during the installation by pressing <F8> on the NIS configuration screen. If you decide at a later time to install NIS, you can do so using the pkgadd(1) command. Go to step 6.
6.Install the Netscape browser. The Netscape browser is provided in the SCO UnixWare CD- ROM Disk 2 of 3.
7.After completing the UnixWare installation, connect the remaining SCSI disks to be configured as part of the RAID subsystem.
8.Boot the system, then insert the SRCU31
a.Create a directory to mount the file. For example, type “mkdir cdfiles” at the prompt.
b.Mount the
9.Install all the Packages/Services Requirements first before installing the components packages. See Table
Table
10.Launch the installer by typing the following:
a.Type “cd /cdfiles/os_setup/unixware”
b.Type “sh install” to start the install script.
c.Select option 1 (by typing 1) to install the requirements and components (Figure
Packages can be individually installed by typing the package number listed on the screen as shown in Figure
Intel® Server RAID Controller |