Intel SRCU31 Advanced Installation Steps, TCP/IP —Microsoft Internet Information Server

Advanced Installation Steps

—TCP/IP

—Microsoft Internet Information Server 2.0.

c. After the NT installation is complete, install the following components and software:

—Microsoft Windows NT 4.0 Service Pack 5 or greater (This will automatically upgrade Internet Information Server 2.0 to Internet Information Server 3.0.).

—Microsoft Internet Explorer 4.00 or greater (recommended) or Netscape Navigator 4.08 or greater.

5.If your browser uses a proxy server, then configure your browser using the procedure in Section B.6, “Browser Configuration During Initial Installation” on page B-5and return to this procedure. If you have not configured your browser to use a proxy server, then go to step 8.

6.Configure Microsoft Internet Information Server

Warning: Due to added security in SRCU31, anonymous connections must be disabled in Microsoft Internet Information Server (IIS) in order to execute the SRCU31 configuration utility in NT. If anonymous connections are allowed to IIS on the target server, then the following message will appear on the web browser after launching the SRCU31 configuration utility shortcut:

Unable to open Driver

Could not open I2O Driver

To avoid the problem described above when attempting to run Storage Console, disable Allow Anonymous connections to Microsoft IIS. Follow the directions below to disable Allow Anonymous connections.

Note: If you need to use the World Wide Web service capabilities of Internet Information Server 4.0 to publish a web site on a server using SRCU31, install IIS 4.0. Reconfigure IIS using the IIS 4.0 instructions in Section 2.5.5, Configuring Microsoft Windows IIS 4.0. Return to this procedure when completed.

If IIS 3.0 is installed on a FAT partition go to step 7. If you need to use IIS 4.0, reconfigure IIS using the IIS 4.0 instructions in Section 2.5.5, Configuring Microsoft Windows IIS 4.0. Go to step 8 when completed. If you are using Microsoft IIS 3.0 on an NTFS partition, proceed to step 8.

7.Configuring Microsoft IIS 3.0

a.Start Internet Services Manager from the Microsoft Internet Server program group.

b.Double-click on the server name in the WWW Service row (top computer name).

c.Under the Service tab in the WWW Service Properties window, clear the Allow Anonymous checkbox in the Password Authentication section. See Figure 2-27.

2-40 Intel® Server RAID Controller U3-1 User’s Manual Rev 1.0