Advanced Installation Steps

BKSTROSM.HAM

SCSIOSM.HAM

HTTP and Winsock Services

RAID Management Agents

Select the desired components and hit <F10> to continue. The appropriate files are copied and the AUTOEXEC.NCF and STARTUP.NCF files are modified as necessary.

Warning: Once the product is installed, check for and remove any duplicate lines in STARTUP.NCF. For example, NetWare 4.2 installations may insert an extra load line for the module PK411.NLM. Remove the extra line.

14.After the installation is complete, reboot the server to load the new drivers.

15.Load Support Pack 8a and reboot.

16.See Chapter 4, Section 4.3, “Configuring RAID Volumes Using the Intel® Integrated RAID Storage Console” on page 4-12to customize your RAID volumes using Storage Console.

NetWare 5

Have all hardware and software on hand. See system requirements in Section 2.5.8.2.

SRCU31 Hardware Installation

For complete hardware installation instructions see Section 2.5.2.3.

Intel Integrated RAID Software Installation

If you do not use the boot capability of the NW5 CD, then replace step 2-5below with steps 2-4of the NetWare 4.2 instructions above.

1.Create and configure a RAID volume using the RAID Configuration Utility. See “How to Invoke Advanced RCU” on page 2-19to create and configure a RAID volume. Once a RAID volume is created and configured, return to this procedure to install the operating system.

2.Insert the NetWare CD-ROM and reboot.

Note: The CMOS may need to be edited on some systems to be set to boot from the CD-ROM. Otherwise, if the system finds a partition on the hard drive it will attempt to boot from it and an error will result.

3.After booting you will first be asked to Accept the License Agreement. Do so. For a brand new volume, you should then select “Create a New Boot Partition”.

4.NetWare will then ask for the size of the boot partition, you can either keep the default of 50MB or hit “Modify” to change the size to suit your needs. When you are done, select “Continue”.

5.It will ask you confirm the boot partition creation. Select “Continue”. You will then press a key to reboot.

6.When NetWare boots again, it will first format the newly created boot partition, and then start loading files. During this initialization, you will see a white graphical NetWare logo screen.

7.It will eventually load a Welcome screen, asking you to verify the startup directory (C:\NWSERVER). Hit <Alt> <F10> to exit the installation. At the console, type “Down”. The installation exits to the boot drive prompt.

Intel® Server RAID Controller U3-1 User’s Manual Rev 1.0

2-55

Page 79
Image 79
Intel SRCU31 user manual Bkstrosm.Ham Scsiosm.Ham