Nortel Networks 553-3001-211 manual CPE LEI/M1

Page 286 of 894 NT5D33 and NT5D34 Lineside E1 Interface cards

Figure 48

Set Mode (S M): Table screen

LEI:>S M

1)Default

2)Table

Hit <CR> to accept current value or type in a new one.

Current Mode : 1 New Mode : 2 Signaling Bits set to Table.

Incoming and outgoing calls are in reference to the CPE.

All ABCD bits are			with respect			to	SENDing		from LEI/M1	to CPE
or RECEIVing		from	CPE	to	LEI/M1.
Please	enter	new	ABCD	bits or		hit	<CR>	to	accept. You	may
enter	2 or 4	values.		If	only	2 values		are entered, the A and
B bits	will	be copied		to	the C	and	D bits.

IDLE SEND: Current: 0000 New: 0101

IDLE SEND bits changed to: 0101

IDLE RECEIVE: Current: 0101 New:

IDLE RECEIVE bits unchanged.

BLOCKING RECEIVE enabled? (Y/N): N

BLOCKING RECEIVE is disabled.

Incoming call RINGER-ON SEND: Current: 0000 New: Incoming call RINGER-ON SEND bits not changed.

Incoming call RINGER-OFF SEND: Current: 0101 New: 0101 Incoming call RINGER-OFF SEND bits not changed.

Incoming call OFFHOOK RECEIVE: Current: 1111 New: 11 Incoming call OFFHOOK RECEIVE bits not changed.

Incoming call CONNECTED SEND: Current: 0101 New: Incoming call CONNECTED SEND bits not changed.

Incoming call (Far End) DISCONNECT SEND: Current: 1111 New: Incoming call (Far End) DISCONNECT SEND bits not changed.

Incoming call (CPE) DISCONNECT RECEIVE: Current: 0101 New: Incoming call (CPE) DISCONNECT RECEIVE not changed.

unable to accept new calls. Set this value to N if this state is not needed. If this value is not set to N, then dip switch #2 position 6 will determine whether off-hook or on-hook is sent to the M1/SL100 when this state is entered. See Table 94 on page 258.

553-3001-211 Standard 2.00 September 2004