Nortel Networks 553-3001-211 manual MMI commands and command sets Part 2 Command Description

NT5D33 and NT5D34 Lineside E1 Interface cards Page 277 of 894

Table 100

MMI commands and command sets (Part 2 of 2)

Command	Description
D S(P)	Display Status. Displays carrier status, including alarm state and, if
	active, alarm level. (Momentarily stop the scrolling display by typing P.
	Continue scrolling by typing any other key.)
H or ?	Help. Displays the Help screen.
L	Login. Logs into the MMI terminal in a single-LEI system.
Lxx	Login. Logs into the MMI terminal in a daisy-chained system, where xx
	represents the address of the card to be configured.
Q	Quit. Logs out of the MMI terminal.
	Note: If it is a daisy-chained system, be certain to log out when finished
	with configuration. In a daisy-chained system, only one card may
	occupy the bus at a given time and all other LEIs will be unable to notify
	the MMI of alarms unless logged-out of configuration mode.
S A	Set Alarm. Sets alarm parameters, such as the allowable bit-errors per
	second, threshold, and alarm duration.
S C	Set Clearing. Sets the alarm self-clearing function, ”enable” or
	”disable.”
S D	Set Date. Sets the date or verifies the current date.
S M	Set Mode. Sets the A/B Bits mode.
S S	Set Simple. Sets whether or not the LEI waits for the terminal
	equipment to return an idle-state message before returning the channel
	to idle at call disconnect from the far-end.
S T	Set Time. Sets the time or verifies current time.
T	Test. Initiates the E1 carrier test function. To terminate a test
	in-process, enter the STOP TEST command at any time.

Circuit Card Description and Installation