Nortel Networks 553-3001-211 manual 604 of 894 NT8D14 Universal Trunk card

Note 2:

Page 604 of 894 NT8D14 Universal Trunk card

Table 185

Jumper strap settings – factory standard (NT8D14BA, NT8D14BB)

		Jumper strap settings (Note 1)
Trunk types	Loop length				J4.X
		J1.X	J2.X	J3.X	(Note 2)
CO/FX/WATS	0–1524 m (5000 ft.)	Off	Off	1–2	1–2
2-way TIE (LDR)
2-way TIE (OAID)
DID	0–600 ohms	Off	Off	1–2	1–2
RAN: continuous	Not applicable: RAN	Off	Off	1–2	1–2
operation mode	and paging trunks
	should not leave the
Paging
	building.

Note 1: Jumper strap settings J1.X, J2.X, J3.X, and J4.X apply to all eight units; “X” indicates the unit number, 0–7. “Off” indicates that no jumper strap is installed on a jumper block. Store unused straps on the universal trunk card by installing them on a single jumper pin as shown below.

For the NT8D14BB card, J4.X is not provided on the card. The J4.X jumper setting specified in Table 185 does not apply.

Jumper strap

Jumper pin

Jumper block

553-6317

553-3001-211 Standard 2.00 September 2004