Nortel Networks 553-3001-211 manual QPC841 Quad Serial Data Interface card Page 869

QPC841 Quad Serial Data Interface card Page 869 of 894

Software service changes

Once the QPC841 QSDI card has been installed in the system, the system software needs to be configured to recognize it. This is done using the Configuration Record program LD 17. Instructions for running the Configuration Record program are found in Software Input/Output: Administration (553-3001-311).

Some of the prompts that are commonly used when running the Configuration Record program LD 17 are shown in LD 17 – Serial port configuration parameters. These parameters must be set for each port that is being used.

LD 17 – Serial port configuration parameters.

Prompt	Response	Description
REQ:	CHG	Change configuration.
TYPE:	CFN	Configuration type.
IOTB	YES	Change input/output devices.
ADAN	NEW TTY x	Define a new system terminal (printer) port as device x, where
	NEW PRT x	x = 0 to 15.
CDNO	1-16	Use the QSDI card number to keep track of all ports.
DENS	DDEN	Double density SDI paddle board.
USER	xxx	Enter the user of port x. The values that can be entered
		depend on the software being used. See Software Input/
		Output: Administration (553-3001-311) for details.
XSM	NO YES	Port is used for the system monitor.

Circuit Card Description and Installation