Nortel Networks 553-3001-211 manual

Page 86 of 894 Circuit card installation

9If there is an enable/disable switch, set it to Enb.

Note: Do not enable the switch on an NT8D04 Superloop Network card or QPC414 Network card until network loop cables are installed.

10If you are adding a voice, conference, or tone and digit loop, press the manual initialize (Man Int) button on the NT5D03 or the NT5D10 Call Processor if the card is associated with the active Call Processor:

Note: An initialization causes a momentary interruption in call processing.

11If you are installing the card in a working system, refer to the work order and the Software Input/Output: Administration (553-3001-311) to add the required office data to the system memory.

12Go to the appropriate test procedure in “Acceptance tests” on page 87.

553-3001-211 Standard 2.00 September 2004