Nortel Networks 553-3001-211 QPC595 Digitone Receiver cards, QPC720 Primary Rate Interface card

Page 148 of 894 Option settings

QPC595 Digitone Receiver cards

	Location	Connection
12 DTMF tones	E9	Center to E3
16 DTMF tones	E9	Center to E2

QPC577, QPC596 Digitone Receiver daughterboards

16/12 tone options jumper	Jumper at P1
16 tone (4 x 4)	connect pins 1 and 2
12 tone (3 x 4)	connect pins 2 and 3

Note: When a DTR daughterboard is installed, check YES on the faceplate of the QPC659 Dual Loop Peripheral Buffer.

QPC720 Primary Rate Interface card

Table 56

QPC720 Primary Rate Interface card (Part 1 of 2)

Switch S2 settings	To repeater facility	To cross-connect point
5 on	0–45 m	0–30 m
	(0–150 ft)	(0–100 ft)
2, 4, 6 on	46–135 m	31–100 m
	(151–450 ft)	(101–355 ft)

Note 1: All positions on S2 (location B22) are OFF except as shown under the column labeled “Switch S2 settings.”

Note 2: Framing format, line encoding, and method of yellow alarm are selectable for both DTI and PRI in LD17 with the DLOP, LCMT, and YALM prompts. All SW3 switch positions should be OFF.

553-3001-211 Standard 2.00 September 2004