Nortel Networks 553-3001-211 manual System DISABLED-FATAL Error

Page 414 of 894 NT6D80 MSDL card

SYSTEM DISABLED—FATAL ERROR

Cause: The MSDL card encountered a fatal error and cannot recover. The exact reason for the fatal error is shown in the MSDL300 error message output to the console of TTY when the error occurred.

Action:

Check the MSDL300 message to find out the reason.

Alternatively, display the status of the MSDL, which also indicates the cause of the problem, with the STAT MSDL x command and check the information to find the cause of the fatal error.

Allow the system to attempt recovery. If this fails, either by reaching a threshold or detecting self-test failure, place the MSDL in the manually disabled state with the DIS MSDL x command and follow the steps in “Previously operating MSDL cards” on page 408.

SYSTEM DISABLED—RECOVERY THRESHOLD

Cause: The system attempted autorecovery of the MSDL card more than five times within 30 minutes and each time the card was disabled again. The system attempts to enable the card again at midnight unless you intervene.

Action:

Place the MSDL card in a manually disabled state with the DIS MSDL x command and follow the steps in “Previously operating MSDL cards” on page 408.

553-3001-211 Standard 2.00 September 2004