654

Page 615 of 894

NT8D15 E&M Trunk card

Contents

This section contains information on the following topics:

Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 615

Physical description. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 617

Functional description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 619

Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 629

Electrical specifications. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 640

Connector pin assignments . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 642

Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 646

Applications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 652

Introduction

The NT8D15 E&M trunk card interfaces four analog telephone trunks to the switch. Each trunk interface connects to a trunk facility using tip and ring leads that carry voice, ringing, and tone signaling, and to signaling interfaces by E&M leads. Each unit can be configured independently by software control in the Trunk Data Block (or Trunk Administration) program LD 14.

You can install this card in any IPE slot.

Note: Up to four analog trunk cards are supported in each MG 1000S and four analog trunk cards in each MG 1000S Expansion.

Circuit Card Description and Installation

Page 615
Image 615
Nortel Networks 553-3001-211 manual NT8D15 E&M Trunk card, Contents