Nortel Networks 553-3001-211 manual Autodial a, Speed Call S, Scr, Enter Access Code SP, XxxCR

NT7D16 Data Access card Page 465 of 894

Autodial (A)

The Autodial command allows the user to dial a predefined number stored within the local system. The DAC will automatically attempt to place a data call to the Autodial number:

A <CR>

CALLING xxxxxxx

RINGING

ANSWERED

CALL CONNECTED. SESSION STARTS

The currently stored Autodial number may be viewed by entering the primary command D (Display), followed by the selection A (Autodial). See the Display discussion later in this document.

Note: If the Autodial feature key is not defined in the software you will

be notified by the following: Feature key Autodial not defined.

Speed Call (S)

The Speed Call command allows the user to make a call to a number associated with a 1-, 2-, or 3-digit access code. The user supplies the access code, and the DAC places the call according to the code supplied.

S<CR>

ENTER ACCESS CODE: <SP>

xxx<CR>

CALLING yyyyyy

RINGING

ANSWERED

CALL CONNECTED. SESSION STARTS

If the DAC does not know the access code length, you will be notified by: ENTER ACCESS CODE (all digits) <SP>. Leading zeroes must be entered

Circuit Card Description and Installation