Page 836 of 894 NTVQ55AA ITG Pentium card

NWK Status LED

NWK Status LEDs display the TLAN interface card Ethernet activity:

Green – on if the carrier (link pulse) is received from the TLAN interface card Ethernet hub.

Yellow – flashes when there is TLAN interface card data activity. During heavy traffic, yellow can stay continuously lit.

Note: There are no Ethernet status LEDs for the ELAN management interface.

PC card slots

The ITG-P card has one faceplate PC card slot, designated drive A. The PC card slot is used for optional maintenance (backup and restore). The ITG-P card also has one unused inboard slot, designated drive B. The PC card slots support PC-based hard disks (ATA interface) or high-capacity PC flash memory cards.

Maintenance Display

Afour character, LED-based, dot matrix display shows the maintenance status fault codes and other card state information.

RS-232 Maintenance Port

The ITG-P card faceplate provides a female DIN-8 serial maintenance port connection (labeled Maint Port). An alternative connection to the faceplate serial maintenance port exists on the NTMF94EA I/O panel breakout cable.

Do not connect maintenance terminals or modems to the faceplate and I/O panel DB-9 male serial maintenance port at the same time.

Backplane interfaces

The backplane connector provides connection to the following:

ELAN interface card

TLAN interface card

553-3001-211 Standard 2.00 September 2004

Page 836
Image 836
Nortel Networks 553-3001-211 manual Backplane interfaces, NWK Status LED, PC card slots, Maintenance Display