Nortel Networks 553-3001-211 Esdi card DTE/DCE mode jumper settings, Mode Port Designations, UA9

QPC513 Enhanced Serial Data Interface card		Page 853 of 894
Table 266
ESDI card DTE/DCE mode jumper settings
		Jumper socket
Mode	Port	designations
Data communication equipment (DTE)	1	UA10	UA12
Data terminal equipment (DCE)	1	UA9	UA11
Data communication equipment (DTE)	2	UA17	UA19
Data terminal equipment (DCE)	2	UA16	UA18
Table 267
ESDI card RS-232-C/high-speed interface jumper settings
		Jumper socket
Mode	Port	designations
RS-232-C interface	1	UB9	UB11
High-speed interface	1	UB10	UB12
RS-232-C interface	2	UB16	UB18
High-speed interface	2	UB17	UB19

Software service changes

All of the other ESDI port operating parameters are defined in software and downloaded to the assigned ESDI port. See Table 261 on page 843. These changes are made using the Configuration Record program (LD 17). Instructions for the Configuration Record program are found in the Software Input/Output: Administration (553-3001-311).

Some of the prompts that are commonly used when running the Configuration Record program (LD 17) are shown in LD 17 – Serial port configuration

Circuit Card Description and Installation