Nortel Networks 553-3001-211 manual NTTK34AA UTP CAT

NTDK20 Small System Controller card Page 805 of 894

Table 254

Expansion daughterboards

			Max. distance between Call
	Number		Server and MG 1000S
Daughterboard	of ports	Cable type	systems
NTDK99 (used in	one	Use the supplied	MG 1000S systems can be
MG 1000S)		NTTK34AA UTP CAT 5	located up to 100 m (328 ft.)
		RJ-45 2 m cross-over	from the Call Server if
NTDK83 (used in	two
		cable to connect the	connected point-to-point, or
Call Server
		Call Server and	up to 40 km (24 miles) from
		MG 1000S using the	the Call Server if a third party
		100BaseT	converter is used to convert to
		daughterboards.	fiber.
		The NTTK34AA
		cross-over cable must
		be used if connecting
		point-to-point.

Note: If not connecting point-to-point, connect the Call Server and

MG 1000S using a straight-through Ethernet UTP Cat 5 cable.

Call Servers can be connected to MG 1000S systems in the following ways:

•Use 100BaseT to connect to the LAN for voice distribution over a data network.

•Use 100BaseT cable if connected point-to-point (directly) to the

MG 1000S. The NTTK34AA crossover cable must be used. MG 1000S systems can be located up to 100 meters from the Call Server.

•Use Media Conversion devices (third party converters) to convert 100BaseT to fiber for distances from 100 m to 40 km.

See Figure 170 on page 806.

Circuit Card Description and Installation