Nortel Networks 553-3001-211 Panel connections, Procedure Cabling the Msdl card to the I/O panel

NT6D80 MSDL card Page 399 of 894

5Plug the DB15 male connector end of the cable into the J5 DB15 female connector on the PRI card.

6Secure the connections in place with their fasteners.

7Repeat steps 1 through 6 for each connection.

End of Procedure

I/O panel connections

Operations aside from PRI require cable connections to the I/O panel. Connections between the I/O panel and Application Equipment Modules (AEM) are described in “Application Module description,” Meridian Link description (553-3201-110).

Procedure 18

Cabling the MSDL card to the I/O panel

The following steps explain the procedure for cable connection:

1Identify the MSDL card and the I/O panel connector to be linked.

2Using the NTND27AB cable, plug the 26-pin SCSI II male connector end of a cable into the appropriate MSDL port.

3Route the cable to the rear of the module next to the I/O panel.

4Plug the DB25 male connector end of a cable into a DB25 female connector at the back of the I/O panel.

5Secure cable connectors in place with their fasteners.

6Repeat steps 1 through 5 for each connection.

End of Procedure

Circuit Card Description and Installation