Nortel Networks 553-3001-211 manual Digitone receiver cards, End of Procedure, LD 34 Stat

Page 90 of 894 Acceptance tests

Again, see “LD 38” in the Software Input/Output: Maintenance (553-3001-511) for detailed information on using this command.

7End the session in LD 38:

****

End of Procedure

Digitone receiver cards

Procedure 3

Testing digitone receiver cards

Use this procedure to test a Digitone receiver (DTR) card, a DTR daughterboard, or the DTR function on the NT8D18 Network/DTR card.

Note: The DTR daughterboard connected to a QPC659 Dual Loop Peripheral Buffer card cannot be assigned when the IPE shelf is used in single loop mode.

1Log into the system: LOGI (password)

2See if the Digitone receiver to be tested is disabled:

LD 34 STAT

The system responds with the terminal number (TN), or numbers, of any disabled Digitone receivers.

3If the Digitone receiver is disabled, enable it: ENLR l s c uloop, shelf, card, and unit numbers

4Test the Digitone receiver:

DTR l s c uloop, shelf, card, and unit numbers

If the system response is other than OK, see the Software Input/Output: Administration (553-3001-311) to analyze the messages.

5End the session in LD 34:

****

End of Procedure

553-3001-211 Standard 2.00 September 2004