Nortel Networks 553-3001-211 manual ATS8?

Page 480 of 894 NT7D16 Data Access card

Table 156

Allowable S registers (Part 2 of 2)

S register	Range	Range units	Supported	Description
S8	0–30	Seconds	Yes	Duration for the dial pause
				character
S9	1–255	0.1 second	No	Carrier detect response time
S10	1–255	0.1 second	No	Delay time between loss of carrier
				and call release
S11	50–255	Milliseconds	No	Touch tone spacing
S12	20–255	20 milliseconds	Yes	Guard time for the escape
				sequence

You can view any of the S registers by issuing the following display command. Any S register can be specified through the ATS command, and the system will display the current setting for that parameter. More than one S register can be viewed by listing the desired registers on the same command line.

One register	Two registers
ATS8?	ATS8? S9
20	002
OK	006
	OK

To change any S register range, except S1, use the following change command. The new parameters remain in effect until another change command is given or the Hayes Reset modem command (Z) is issued. If the DAC is powered up, the parameters are reset to the defaults.

ATS8 = 15

OK

553-3001-211 Standard 2.00 September 2004