Nortel Networks 553-3001-211 manual Faceplate components, ITG-P LED Card Status

Page 834 of 894 NTVQ55AA ITG Pentium card

Functional description

Figure 178 on page 835 shows the ITG-P card faceplate components. The information in this section describes the components.

Faceplate components

NWK

The faceplate connector labeled NWK is a 9-pin, sub-miniature D-type connector. The connector is not used for the ITG-P application.

WARNING

The NWK connector looks like a 9-pin serial connector. Do not connect a serial cable or any other cable to it. If a cable is installed to the NWK connector, the TLAN interface card is disabled.

ITG-P LED (Card Status)

The red status faceplate LED indicates the enabled/disabled status of the 24-card ports. The LED is on (red) during the power-up or reset sequence. The LED remains lit until the card is enabled. If the LED remains on, this indicates the self-test failed, the card is disabled, or the card rebooted.

Reset switch

Press the Reset switch to reset the card without having to cycle power to the card. This switch is normally used after a software upgrade to the card, or to clear a fault condition.

553-3001-211 Standard 2.00 September 2004