Cisco Systems ASR 1000 Series manual Removing a Cisco ASR1000-ESP

Chapter 8 Replacing Cisco ASR 1000 Series Routers Field-Replaceable Units

Removing and Replacing the Cisco ASR 1000 Series Embedded Service Processors

Figure 8-14 Cisco ASR 1000 Series Route Processor 1 Flash Token Memory Stick

PWR STAT ASR1000-

ACTV	CRIT
	MAJ
STBY

1

HD

USB

BF

DISK

280382

Note You can insert or remove the memory stick whether the router is powered on or not.

This completes the USB Flash memory installation procedure.

Removing and Replacing the Cisco ASR 1000 Series Embedded Service Processors

The following sections describe the procedures for replacing a Cisco ASR 1000 Series Embedded Service Processors (Cisco ASR1000-ESP5, Cisco ASR1000-ESP10, or Cisco ASR1000-ESP20) in your system. The module also contains card handles to assist in insertion and removal of the module and retention of the module into the chassis. The Cisco ASR 1000 Series Embedded Services Processors have no front panel I/O connectors.

Note The Cisco ASR 1000 Series Embedded Services Processor is a field-replaceable unit in the Cisco ASR 1002 Router and the Cisco ASR 1002 Router supports only the Cisco ASR1000-ESP5 and Cisco ASR1000-ESP10, not the Cisco ASR1000-ESP20.

Note Before beginning the procedure, verify that your system meets the minimum requirements as described in Chapter 2, “Cisco ASR 1000 Series Routers Components.”

Removing a Cisco ASR1000-ESP

To remove the Cisco ASR1000-ESP5, Cisco ASR1000-ESP10, or Cisco ASR1000-ESP20 from the Cisco ASR 1000 Series Routers, follow this procedure:

Step 1 Slip on the ESD-preventative wrist strap that was included in the accessory kit. Loosen the captive screws on the Cisco ASR 1000 Series Embedded Services Processor.

	Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
OL-13208-03		8-17