Chapter 8 Replacing Cisco ASR 1000 Series Routers
Removing and Replacing a Cisco ASR 1006 Router Power Supply
Refer to the following example to shut down the interface FastEthernet0/1/0 on the
a.At the router# prompt, type:
configure terminal and press Enter. The global configuration mode prompt Router (config)# appears.
b.At the router (config)# prompt, type:
interface FastEthernet0/1/0 and press Enter. The interface configuration mode prompt
c.At the router
shutdown and press Enter. This disables the interface FastEthernet0/1/0.
d.At the
end and press Enter. The privileged EXEC mode prompt Router# appears.
Step 3 Disconnect all cables from the shared port adapter.
Step 4 Unscrew the captive installation screws on either side of the SPA.
Step 5 Grasp the handles and pull the SPA from the SIP.
You have completed the removal procedure for the Cisco ASR1000 Series SPA.
Replacing a Shared Port Adapter In a SIP
To replace a shared port adapter in a SIP module, follow these steps:
Step 1 To insert the SPA in the SIP, locate the guide rails inside the SIP that hold the SPA in place. They are at the top left and top right of the SPA slot and are recessed about an inch.
Step 2 Carefully slide the SPA all the way in the SIP until the SPA is firmly seated in the SPA interface connector. When fully seated, the SPA might be slightly behind the SIP faceplate.
Step 3 After the SPA is properly seated, fasten the SPA in place with the captive installation screws on either side of the SPA.
Removing and Replacing a Cisco ASR 1006 Router Power Supply
This section provides information about removing and replacing the following power supplies in a Cisco ASR 1006 Router:
•AC power supply
•DC power Supply
| Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide |
|
