Cisco Systems ASR 1000 Series manual Equipment Shelf or Tabletop Installation

Chapter 6 Cisco ASR 1002 Router Overview and Installation

Equipment Shelf or Tabletop Installation

Equipment Shelf or Tabletop Installation

To mount your Cisco ASR 1002 Router on an equipment shelf or tabletop, follow these steps.

Step 1 Remove any debris and dust from the tabletop or platform, as well as the surrounding area. Step 2 Lift the chassis into position on the equipment shelf or tabletop.

Warning At least two people are required to lift the chassis onto a tabletop or platform. To prevent injury, keep your back straight and lift with your legs, not your back. Statement 164

Figure 6-7 Lifting the Chassis

POWER

FAULT

MISWIRE

POWER

FAULT

MISWIRE

1 2

3
4	0A	5
	PROCESSOR ONLY
	0B

6 7

8

0 0

1	0
1	0	0
2	1
2	1	1
3	2
3	2	2

4	3
4	3	3
5	4
5	4	4
	5
	5	5

PROCESSOR ONLY

30007

Note The chassis in Figure 6-7does not represent the Cisco ASR 1002 Router.

Step 1 Attach the front rack-mount brackets. Locate the threaded holes in the front sides of the chassis (first holes beyond the vent holes) and use the package of black screws that shipped with the chassis.

Step 2 Align the front rack-mount bracket to one side of the chassis.

Step 3 Insert and tighten the screws on one side.

Step 4 Repeat Step 2 through Step 3 on the other side of the chassis. Use all screws to secure the rack-mount brackets to the chassis.

Note The chassis rack-mount brackets must be installed first so that you can attach the cable-management brackets to the chassis rack-mount brackets after the chassis is installed in the rack.

Step 5 Obtain the two cable-management brackets and screws shipped with your chassis. Figure 6-8shows attached cable-management brackets on the front of the Cisco ASR 1002 Router.

	Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
6-12	OL-13208-03