Chapter 8 Replacing Cisco ASR 1000 Series Routers
Removing and Replacing a Cisco ASR 1006 Router Power Supply
This completes the procedure for installing the AC power supply in the Cisco ASR 1006 Router.
Removing and Replacing a DC Power Supply in Cisco ASR 1006 Router
This section provides information about removing and installing a DC power supply in the Cisco ASR 1006 Router.
Warning When you install the unit, the ground connection must always be made first and disconnected last. Statement 1046
Warning Before performing any of the following procedures, ensure that power is removed from the DC circuit. Statement 1003
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030
Figure 8-18 shows the DC power supply and components for the Cisco ASR 1006 Router.
Figure 8-18 Cisco ASR 1006 Router DC Power Supply
910
8
7
| OUTPUT INPUT | INPUT | |
OFF | FAIL | OK | OK |
55
|
|
| ALARMS | ||
| 40A | 60V |
|
| |
| 1A MAX | ||||
|
|
| |||
This unit might have more than one power supply connection. All connections must be removed to
6 | 5 | 4 | 3 | 2 | 1 |
280023
1 | Fan | 6 | DC power supply ground studs |
|
|
|
|
2 | 7 | DC power supply captive screw | |
|
|
|
|
3 | 8 | DC power supply handle | |
|
|
|
|
4 | DC power supply terminal block and plastic | 9 | On/Off (/O) circuit breaker switch |
| cover |
|
|
|
|
|
|
5 | Earth ground symbol | 10 | Power supply LEDs: |
|
|
|
|
Warning Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Statement 1003
|
| Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide |
|
| |
|
|
| |||
|
|
|
|
| |
|
|
|
| ||
