Cisco Systems ASR 1000 Series manual One RJ-45 for CON Console port used to connect to a terminal

Chapter 2 Cisco ASR 1000 Series Routers Components

Cisco ASR 1000 Series Route Processor

Table 2-3	Cisco Embedded ASR1000-RP1 LEDs (continued) in the Cisco ASR 1002 Router
LED Label	LED	Color —State	Behavior Description
LINK	10/100 /1000 RJ-45	Green	Link with no activity.
	Interface LED
		Flashing Green	Link with activity.
		Off	No link.
4 LEDs	Built-in SPA SFP	Off	Port is not enabled.
	port status
		Amber	Port enabled but there is a problem with the
			Ethernet link.
		Green	Port enabled, valid Ethernet link
PWR	Carrier card power	Green	All carrier card requirements are within
			specification.
STAT	Carrier card status	Green	Only when the SPA drivers have started and
			are running and all critical processes are
			running
		Yellow	When ROMMON is running and during the
			download and boot of the operating system
		Red	A fault is detected or the card is powering
			up.

Table 2-4lists the Cisco embedded ASR1000-RP1in the Cisco ASR 1002 Router connectors and description.

Table 2-4	Cisco Embedded ASR1000-RP1 Connectors
Label		Type	Description
BITS		Standard E1/T1 RJ-45	Indicates BITS timing references.
		connector
MGMT		One RJ-45 jack for	The route processor has an ENET port with a RJ-45
		copper Ethernet	connector to attach a management device or network
		Management Ethernet	for network management.
		Port
CON		One RJ-45 for CON	Console port used to connect to a terminal.
AUX		One RJ-45 for AUX	Auxiliary port used for remote management
			purposes.

Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide

2-8 OL-13208-03