Chapter 8 Replacing Cisco ASR 1000 Series Routers Field-Replaceable Units

Removing and Replacing a Cisco ASR 1006 Router Power Supply

Step 6 Grasping the power supply handles, pull the power supply from the chassis.

Step 7 Replace the AC power supply within 5 minutes.

This completes the procedure for removing the AC power supply from the Cisco ASR1006 chassis.

Replacing the AC Power Supply in Cisco ASR 1006 Router

This section provides information about installing an AC power supply in the Cisco ASR 1006 Router.

Warning Never install an AC power module and a DC power module in the same chassis. Statement 1050

Figure 8-17 Cisco ASR 1006 Router AC Power Supply

5

4

6

7

8

OUTPUT INPUT INPUT

FAIL OK OK

ALARMS 60V 1A MAX

100-240V~ 16-7A

50-60HZ

This unit might have more than one power supply connection. All connections must be removed to de-energize the unit.

280029

3

2

1

 

1

AC power supply fan

5

AC power supply handle

 

 

 

 

 

 

2

AC power supply DB-25 alarm connector

6

AC power inlet

 

 

 

 

 

 

3

Cable tie wrap tabs

7

AC power supply Standby switch (standby

 

 

 

 

symbol is a broken circle with a vertical line

 

 

 

 

through the top of it). A Standby switch is not

 

 

 

 

considered a disconnect.

 

 

 

 

 

 

4

AC power supply captive screws

8

AC power supply LEDs

 

 

 

 

 

 

 

 

 

 

Step 1

Insert an AC power supply in power supply slot 0 or power supply slot 1 until it is fully seated.

Step 2

Tighten the captive screws.

 

 

Step 3

Insert the AC power cable.

 

 

Step 4

Plug the power supply cable into the power source.

 

 

Step 5

Turn the power supply Standby switch to the On (I) position.

 

 

 

 

 

 

Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide

8-24

OL-13208-03

Page 230
Image 230
Cisco Systems ASR 1000 Series manual Replacing the AC Power Supply in Cisco ASR 1006 Router, Insert the AC power cable