Chapter 8 Replacing Cisco ASR 1000 Series Routers Field-Replaceable Units

Removing and Replacing a Cisco ASR 1006 Router Power Supply

Removing the AC Power Supply from Cisco ASR 1006 Router

Because of the power supply redundancy, there is no need to power off the Cisco ASR 1006 Router before removing one of the AC power supplies.

The Cisco ASR 1006 Router has two of the same type power supplies in power supply slot 0 and power supply slot 1.

To remove a Cisco ASR 1006 Router AC power supply that is not operating normally (and then replace the AC power supply within five minutes), follow this procedure:

Step 1 Slip on the ESD-preventative wrist strap that was included in the accessory kit.

Step 2 Before you turn off a power supply, make certain the chassis is grounded.

Step 3 Turn the power supply Standby switch to the Standby position.

Figure 8-16 AC Power Inlet and Standby Switch

1

2

100-240V~

16-7A

 

50-60HZ

 

 

 

 

This

 

 

 

 

 

 

 

unit

 

 

 

 

 

 

 

might

 

 

 

one

power

have

more

than

supply

 

All conne

 

connection.

ctions

to de-en

 

 

must

be removed

ergize the

 

 

 

 

 

unit.

 

280083

1

Power inlet

2

Power supply AC Standby switch

Step 4 Unplug the power cable from the AC inlet on the back of the power supply and the power source. Step 5 Unscrew the power supply captive screws.

Note Two power supplies must be installed in the chassis at all times to ensure sufficient cooling. The system fans are inside the power supply units and must spin for cooling. Because all the system fans can be powered by one power supply, the second power supply unit does not have to be powered on, but it must be installed.

Caution If you remove a power supply, the system can run for a maximum of five minutes before the system shuts down. The fans and power elements are independent within the power supply. Therefore, it is not required that the replacement power supply be energized within five minutes. The only requirement is that the power supply be installed in the chassis, which energizes the fans and maintains proper system cooling.

 

 

Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide

 

 

 

 

 

 

OL-13208-03

 

 

8-23

 

 

 

 

 

Page 229
Image 229
Cisco Systems ASR 1000 Series manual Removing the AC Power Supply from Cisco ASR 1006 Router, 50-60HZ This