Chapter 6 Cisco ASR 1002 Router Overview and Installation
Connecting Shared Port Adapter Cables
Step 4 Locate the chassis ground connector on the side of your chassis.
Figure 6-17 Attaching a Grounding Lug to the Chassis Ground Connector
2
1
280284
1
Chassis ground connector
2
Earth ground symbol
Step 5 Insert the two screws through the holes in the grounding lug.
Step 6 Use the Number 2 Phillips screwdriver to carefully tighten the screws until the grounding lug is held firmly to the chassis. Do not overtighten the screws.
Step 7 Connect the opposite end of the grounding wire to the appropriate grounding point at your site to ensure an adequate chassis ground.
This completes the procedure for attaching a chassis ground connection. Go to the following cabling sections for information on attaching cables.
Connecting Shared Port Adapter Cables
The instructions for connecting the cables for the shared port adapter installed in the Cisco ASR 1002 Router are contained in the respective configuration documents for each port adapter. For example, if you are connecting the optical fiber cables for the
|
| Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide |
|
| |
|
|
| |||
|
|
|
|
| |
|
|
|
| ||
