Cisco Systems ASR 1000 Series manual Removing the DC Power Supply from Cisco ASR 1006 Router

Chapter 8 Replacing Cisco ASR 1000 Series Routers Field-Replaceable Units

Removing and Replacing a Cisco ASR 1006 Router Power Supply

Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030

Warning Installation of the equipment must comply with local and national electrical codes. Statement 1074

Removing the DC Power Supply from Cisco ASR 1006 Router

Before you can remove a DC power supply from the Cisco ASR 1006 Router, you must remove power from the power supply. Follow these steps to remove power and the DC power supply from the chassis.

Caution Make certain that the chassis ground is connected before you begin removing and installing the power supply. For the chassis ground stud location.

Step 1 Before servicing the power supply, switch the circuit breaker Off in your equipment area. As an additional precaution, tape the circuit breaker switch in the Off position.

Step 2 Slip on the ESD-preventative wrist strap that was included in the accessory kit.

Step 3 Switch the power supply circuit breaker switch to Off (O).

Step 4 Locate the terminal block on the rear of the chassis on the power supply.

Figure 8-19shows the DC power supply terminal block.

	Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
8-26	OL-13208-03