Cisco Systems ASR 1000 Series manual Rack-Mounting a Cisco ASR 1002 Router

Chapter 6 Cisco ASR 1002 Router Overview and Installation

Rack-Mounting a Cisco ASR 1002 Router

Note Make certain that the cable-management ‘U’ feature device has the open end pointing upwards when you attach it to the chassis

Figure 6-8 Attaching the Cable-Management Brackets to the Cisco ASR 1002 Router

1

3

2

						SPA-4XOC3-POS
					PWR STAT	3
				AUX	CON	2
				MGMT		1
				LINK
			CARRIER	MTS		0
		BOOT				SPA-4XOC3-POS
		QE3
		QE2				3
		QE1
	STAT	QE0				2
ASR 100	2					1
						0
stat	min
	maj
pwr				SPA-4XOC3-POS
	crit
				3
			2
		1
		0

1

280280

1	Cable-management bracket top and bottom	3	Chassis front rack-mount bracket
	screw
2	Cable-management bracket

Step 6 Screw the cable-management bracket to each side of the rack-mount brackets already attached to the chassis. Use two screws for each cable-management bracket. Use the package of four screws.

Step 7 Check that all screws are securely tightened.

Step 8 Go to the “Attaching a Chassis Ground Connection” section on page 6-23to continue the installation.

Rack-Mounting a Cisco ASR 1002 Router

The Cisco ASR 1002 Router can be installed in an existing rack with equipment or in an empty rack with no equipment: The chassis can be mounted in either rack types:

•Two-post rack, either 19 inch or 23 inch. Inner clearance (the width between the inner sides of the two posts or rails) must be at least 19 inches (48.26 cm). The height of the chassis is 3.47 inches (8.8 cm). Airflow through the chassis is from front to back.

Note If you are using a two-post rack secure the rack to the floor surface to prevent tipping and avoid bodily.

	Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
OL-13208-03		6-13