Chapter 8 Replacing Cisco ASR 1000 Series Routers
Removing and Replacing a DC Power Supply in Cisco ASR 1004 Router
Step 6 Grasping the power supply handles, pull the power supply from the chassis.
Step 7 Replace the AC power supply within five minutes.
This completes the procedure for removing the AC power supply from the Cisco ASR1004 chassis.
Replacing the AC Power Supply in Cisco ASR 1004 Router
This section provides information about installing an AC power supply in the Cisco ASR 1004 Router.
Warning Never install an AC power module and a DC power module in the same chassis. Statement 1050
Step 1 Insert an AC power supply in power supply slot 0 or power supply slot 1 until it is fully seated. Step 2 Tighten the captive screws.
Step 3 Insert the AC power cable.
Step 4 Plug the power supply cable into the power source.
Step 5 Turn the power supply Standby switch to On () position.
This completes the procedure for installing the AC power supply in a Cisco ASR 1004 Router.
Removing and Replacing a DC Power Supply in Cisco ASR 1004 Router
This section provides information about removing and installing a DC power supply in the Cisco ASR 1004 Router.
Warning When you install the unit, the ground connection must always be made first and disconnected last. Statement 1046
Warning Before performing any of the following procedures, ensure that power is removed from the DC circuit. Statement 1003
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030
|
| Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide |
|
| |
|
|
| |||
|
|
|
|
| |
|
|
|
| ||
