Chapter 4 Cisco ASR 1006 Router Overview and Installation

Attaching a Chassis Ground Connection

Caution The dual-lug chassis stud must be installed, the SIP and SPA must be fully inserted and screwed in and earthed to prevent a potential hazard in a telecom line.

Have the recommended tools and supplies available before you begin this procedure.

Figure 4-11shows the cable-management brackets attached to the chassis in a rack.

Figure 4-11 Installing the Cisco ASR 1006 Router Ground Connection

4

3

2 1

280034

1

Chassis earth ground studs and lead wire

3

Earth ground connector on the chassis

 

 

 

 

2

Grounding screws

4

Earth ground symbol

 

 

 

 

Warning This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024

Before you connect power or turn on power to your chassis, you must provide an adequate chassis ground (earth) connection for the chassis. A chassis ground connector is provided on each Cisco ASR 1006 Router. There is a stud on the side of the chassis and on the DC power supply (primary grounding stud).

Caution The grounding wire is always the first to be installed or connected and the last to be removed or disconnected.

 

Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide

4-18

OL-13208-03

Page 116
Image 116
Cisco Systems ASR 1000 Series manual Installing the Cisco ASR 1006 Router Ground Connection