Chapter 8 Replacing Cisco ASR 1000 Series Routers
Removing and Replacing a Cisco ASR 1002 Router Power Supply
Warning Before performing any of the following procedures, ensure that power is removed from the DC circuit. Statement 1003
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030
Figure 8-33 shows the DC power supply and components for the Cisco ASR 1002 Router.
Figure 8-33 Cisco ASR 1002 Router DC Power Supply
1 | 2 | 3 | 4 | 5 | 6 |
| OUTPUT INPUT | FAN | OUTPUT INPUT | FAN | ||
| FAIL | OK | OK | FAIL | OK | OK |
0 | This unit might have more than | This unit might have more than | ||||
one power supply connection. | one power supply connection. | |||||
All connections must be removed | All connections must be removed | |||||
| to |
| to |
|
|
|
| 1 | 280289 |
| - |
| ||
|
|
|
| |
10 | 9 | 8 | 7 |
|
|
|
1 | DC power supply ESD socket | 6 | DC power supply captive installation screw |
|
|
|
|
2 | DC power supply slot 0 label | 7 | DC power supply slot 1 label |
|
|
|
|
3 | DC power supply switch Standby/On (I) | 8 | Earth ground (GND) |
| (standby symbol is a broken circle with a |
|
|
| vertical line through the top of it) |
|
|
|
|
|
|
4 | DC power supply LEDs | 9 | Positive lead |
|
|
|
|
5 | Fan | 10 | Negative lead |
|
|
|
|
Warning Before performing any of the following procedures, ensure that power is removed from the DC circuit. Statement 1003
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030
Warning Installation of the equipment must comply with local and national electrical codes. Statement 1074
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
|
| |
|