Chapter 6 Cisco ASR 1002 Router Overview and Installation
Cisco ASR 1002 Router Description
Table
|
| Table | Cisco ASR | ||
|
|
|
|
|
|
No | LED Label | LED |
| Color | In the Power Up State |
|
|
|
|
|
|
1 | PWR | Power |
| Solid green | All power supplies are within operational limits. |
|
|
|
|
|
|
|
|
|
| Off | Off, the router is in standby mode. |
|
|
|
|
|
|
2 | ACTV | Active |
| Green | The embedded services processor is green when |
|
|
|
|
| active. |
|
|
|
|
|
|
3 | STAT | STATUS |
| Green | Code has successfully downloaded and is |
|
|
|
|
| operational. |
|
|
|
|
|
|
|
|
|
| Yellow | BOOT ROM has successfully loaded. |
|
|
|
|
|
|
|
|
|
| Red | Not booted. |
|
|
|
|
|
|
4 | STBY | Standby |
| None | Will always be off. |
|
|
|
|
|
|
Note The Cisco ASR
Power Supplies in the Cisco ASR 1002 Router
The Cisco ASR 1002 Router power supply module consists of either an AC or DC input in a closed frame power supply with two DC voltage outputs: +12V and 3.3V. The AC power supply operates between 85VAC to 264VAC and DC operates between
The power supplies are installed into the rear of the chassis and are hot pluggable. The Cisco ASR 1002 Router supports up to 588W input power from an infrastructure standpoint (cooling capacity, midplane and power distribution) but initial power supply development limit is up to 470W output (AC and DC Input).
AC Power Supply for Cisco ASR 1002 Router
The AC power supply input inlet is an IEC connector with AC switch and the current rating on the connector and switch is 10 Amps. The AC power supply is secured into the chassis with two captive screws mounted on the faceplate.
Table
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide
|
| |
|
