Chapter 5 Cisco ASR 1004 Router Overview and Installation

Connecting Power to Cisco ASR 1004 Router

An earth ground cable is required for each DC PDU. We recommend that you use at least 6-AWG multistrand copper wire. This wire is not available from Cisco Systems; it is available from any commercial cable vendor.

The ground wire cable lug should be dual-hole (as shown in Figure 5-18) and able to fit over M6 terminal studs at 0.625-inch (15.88-mm) centers. Recommended lug terminal wire size Panduit part number:

LCD8-14A-L for 8AWG wire size

LCD6-14A-L for 6AWG wire size

Figure 5-18 DC Input Power Cable Lug

End View

0.48Ø 0.267 2 holes

All measurements in inches

2.24

0.25 0.63 0.37 0.08

Crimp area

25527

Note To avoid hazardous conditions, all components in the area where DC input power is accessible must be properly insulated. Therefore, before installing the DC cable lugs, be sure to insulate the lugs according to the manufacturer’s instructions.

Warning When you install the unit, the ground connection must always be made first and disconnected last. Statement 1046

Warning When you install the unit, the ground connection must always be made first and disconnected last. Statement 1046To connect the Cisco ASR 1004 Router DC power supply, follow these steps:

Step 1 Make certain that the chassis grounding is connected before you begin installing the DC power supply. Step 2 Locate the terminal block and remove the plastic cover.

a.Unscrew and remove the two screws.

b.Slide the plastic cover off of the terminal block.

 

Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation and Initial Configuration Guide

5-26

OL-13208-03

Page 154
Image 154
Cisco Systems ASR 1000 Series manual DC Input Power Cable Lug