Delta Electronics VFD-VL manual 05-12, 05-13

					Chapter 4 Parameters
	05-06	Rs of Motor			Unit: 0.001
	Control	SVC	FOCPG	TQCPG	Factory setting: 0.000
	mode
	05-07	Rr of Motor			Unit: 0.001
	Control	SVC	FOCPG	TQCPG	Factory setting: 0.000
	mode
		Settings	0.000~65.535Ω
	05-08	Lm of Motor			Unit: 0.1
	Control	SVC	FOCPG	TQCPG	Factory setting: 0.0
	mode
05-09		Lx of Motor			Unit: 0.1
	Control	SVC	FOCPG	TQCPG	Factory setting: 0.0
	mode
		Settings	0.0~6553.5mH
	05-10	Torque Compensation Time Constant			Unit: 0.001
	Control	SVC			Factory setting: 0.020
	mode
		Settings	0.001 to 10.000 sec
05-11		Slip Compensation Time Constant			Unit: 0.001
	Control	SVC			Factory setting: 0.100
	mode
		Settings	0.001 to 10.000 sec

Setting Pr.05-10 and Pr.05-11 change the response time for the compensation.

When Pr.05-10 and Pr.05-11 are set to 10 seconds, its response time for the compensation will be the longest. But if the settings are too short, unstable system may occur.

05-12	Torque Compensation Gain		Unit: 1
Control	VF	VFPG	Factory setting: 0
mode
	Settings	0 to10
This parameter may be set so that the AC motor drive will increase its voltage output to obtain
a higher torque.
05-13	Slip Compensation Gain		Unit: 0.01
Control	SVC	VFPG SVC	Factory setting: 0.00
mode
	Settings	0.00 to10.00

Revision Nov. 2008, VLE1, SW V1.03 4-59