Delta Electronics VFD-VL manual External Wiring

Chapter 2 Installation and Wiring

2.2 External Wiring

Power Supply

			FUSE/NFB
			Magnetic
			contactor
			Input AC
			Line Reactor
			Zero-phase
			Reactor
	EMI Filter
R/L1	S/L2	T/L3		res ister
			+/B1	Brak e
			B2
U/T1	V/T2		-
		W/T3
			Zero-phase
			Reactor
			Output AC
			Line Reactor
	Motor

Items	Explanations
Power	Please follow the specific power
	supply requirements shown in
supply
	Appendix A.
	There may be an inrush current
Fuse/NFB	during power up. Please check the
	chart of Appendix B and select the
(Optional)
	correct fuse with rated current. Use of
	an NFB is optional.
Magnetic	Please do not use a Magnetic
	contactor as the I/O switch of the AC
contactor
	motor drive, as it will reduce the
(Optional)
	operating life cycle of the AC drive.
	Used to improve the input power
	factor, to reduce harmonics and
	provide protection from AC line
Input AC	disturbances. (surges, switching
	spikes, short interruptions, etc.). AC
Line Reactor
	line reactor should be installed when
(Optional)	the power supply capacity is 500kVA
	or more and exceeds 6 times the
	inverter capacity, or the mains wiring
	distance ≤ 10m.
	Zero phase reactors are used to
Zero-phase	reduce radio noise especially when
	audio equipment is installed near the
Reactor
	inverter. Effective for noise reduction
(Ferrite Core
	on both the input and output sides.
Common	Attenuation quality is good for a wide
Choke)
	range from AM band to 10MHz.
(Optional)
	Appendix B specifies the zero phase
	reactor. (RF220X00A)
EMI filter	To reduce electromagnetic
	interference, please refer to Appendix
(Optional)
	B for more details.
	Used to reduce the deceleration time
Brake
	of the motor. Please refer to the chart
Resistor
	in Appendix B for specific Brake
(Optional)
	Resistors.
	Motor surge voltage amplitude
Output AC
	depends on motor cable length. For
Line Reactor
(Optional)	applications with long motor cable
	(>20m), it is necessary to install a
	reactor at the inverter output side.

2-6 Revision Nov. 2008, VLE1, SW V1.03