Delta Electronics VFD-VL manual 06-05, 06-06, 06-07, 06-08, 06-09

Chapter 4 Parameters

It is used to set the accel./decel. time selection when stall prevention occurs at constant speed.

06-05	Over-torque Detection Selection (OT1)
Control	VF	VFPG	SVC		FOCPG TQCPG FOCPM	Factory setting: 0
mode
	Settings	0		Over-Torque detection disabled.
		1		Over-torque detection during constant speed operation, continue to
				operate after detection
		2		Over-torque detection during constant speed operation, stop
				operation after detection
		3		Over-torque detection during operation, continue to operate after
				detection
		4		Over-torque detection during operation, stop operation after
				detection
06-06	Over-torque Detection Level (OT1)					Unit: 1
Control	VF	VFPG	SVC		FOCPG TQCPG FOCPM	Factory setting: 150
mode
	Settings	10 to 250%
06-07	Over-torque Detection Time (OT1)					Unit: 0.1
Control	VF	VFPG	SVC		FOCPG TQCPG FOCPM	Factory setting: 0.1
mode
	Settings	0.0 to 60.0 sec
06-08	Over-torque Detection Selection (OT2)
Control	VF	VFPG	SVC		FOCPG TQCPG FOCPM	Factory setting: 0
mode
	Settings	0		Over-Torque detection disabled.
		1		Over-torque detection during constant speed operation, continue to
				operate after detection
		2		Over-torque detection during constant speed operation, stop
				operation after detection
		3		Over-torque detection during operation, continue to operate after
				detection
		4		Over-torque detection during operation, stop operation after
				detection
06-09	Over-torque Detection Level (OT2)					Unit: 1
Control	VF	VFPG	SVC		FOCPG TQCPG FOCPM	Factory setting: 150
mode
	Settings	10 to 250%

4-64 Revision Nov. 2008, VLE1, SW V1.03