Delta Electronics VFD-VL manual Group 11 Advanced Parameters

Chapter 4 Parameters

Group 11 Advanced Parameters

				Setting	VF	VFPG	SVC	FOCPG	TQCPG	FOCPM
	Pr.	Explanation	Settings	Factory
			Bit 0=0: no function	0				○		○
			Bit 0=1: ASR Auto tuning, PDFF enable
			Bit 7=0: no function
		System Control	Bit 7=1: When position control is enabled, it doesn’t need to set
11-00			Pr.07-02 (DC Brake Current Level)
			Bit 15=0: when power is applied, it will detect the position of
			magnetic field again
			Bit 15=1: when power is applied, it will start from the magnetic
			field position of previous power failure
11-01		Elevator Speed	0.10~3.00 m/s	1.00				○		○
11-02		Sheave Diameter	100~2000 mm	400				○		○
11-03		Mechanical Gear Ratio	1~100	1				○		○
11-04		Suspension Ratio	0: 1:1	1				○		○
			1: 2:1
11-05		Inertial Ratio	1~300%	40				○		○
11-06		Zero-speed Bandwidth	0~40Hz	10				○		○
11-07		Low-speed Bandwidth	0~40Hz	10				○		○
11-08		High-speed Bandwidth	0~40Hz	10				○		○
11-09		PDFF Gain Value	0~200%	30				○		○
11-10		Gain for Speed Feed	0~500	0				○		○
		Forward
11-11		Notch Filter Depth	0~20db	0				○		○
11-12		Notch Filter Frequency	0.00~200.00Hz	0.00				○		○
11-13		Low-pass Filter Time of	0.001~65.535s	0.500	○	○	○	○	○	○
		Keypad Display
11-14		Motor Current at Accel.	50~200%	150						○
11-15		Elevator Acceleration	0.60~2.00m/s	0.75						○
11-16		Reserved
11-17		Reserved
11-18		Reserved

Revision Nov. 2008, VLE1, SW V1.03 4-17