Delta Electronics VFD-VL manual 02-10, MI8 MI7 MI6 MI5 MI4 MI3 MI2 MI1 REV, 02-11, 02-12

Chapter 4 Parameters

02-10	Digital Input Operation Direction		Unit: 1
Control	VF	VFPG SVC FOCPG TQCPG FOCPM	Factory setting: 0
mode
	Settings	0 ~ 65535

This parameter is used to set the input signal level and it won’t be affected by the SINK/SOURCE status.

Bit0 is for FWD terminal, bit1 is for REV terminal and bit2 to bit9 is for MI1 to MI8. User can change terminal status by communicating.

For example, MI1 is set to 1 (multi-step speed command 1), MI2 is set to 2 (multi-step speed command 2). Then the forward + 2nd step speed command=1001(binary)=9 (Decimal). Only need to set Pr.02-10=9 by communication and it can forward with 2nd step speed. It doesn’t need to wire any multi-function terminal.

bit9

bit8

bit7

bit6

bit5

bit4

bit3

bit2

bit1

bit0

MI8

MI7

MI6

MI5

MI4

MI3

MI2

MI1

REV

FWD

02-11

Multi-function Output 1 RA, RB, RC (Relay1)

Factory Setting: 11

02-12

Multi-function Output 2 MRA, MRC (Relay2)

Factory Setting: 1

02-13Multi-function Output 3 (MO1)

02-14Multi-function Output 4 (MO2)

02-15Multi-function Output 5 (MO3) (need to use with EMVL-IODA01)

02-16Multi-function Output 6 (MO4) (need to use with EMVL-IODA01)

02-17Multi-function Output 7 (MO5) (need to use with EMVL-IODA01)

02-18Multi-function Output 8 (MO6) (need to use with EMVL-IODA01)

02-19Multi-function Output 9 (MO7) (need to use with EMVL-IODA01)

02-20Multi-function Output 10 (MO8) (need to use with EMVL-IODA01)

02-21Multi-function Output 11 (MO9) (need to use with EMVL-IODA01)

02-22Multi-function Output 12 (MO10) (need to use with EMVL-IODA01)

Factory Setting: 0

Settings 0-41

Settings

0:No function

1:Operation indication

VF

○

○

VFPG

○

○

Control Mode

SVC	FOCPG	TQCPG	FOCPM
○	○	○	○
○	○	○	○

4-42 Revision Nov. 2008, VLE1, SW V1.03