Delta Electronics VFD-VL manual Pr.06-06, Pr.06-09, Pr.06-07, 06-10, 06-11

			Chapter 4 Parameters
06-10	Over-torque Detection Time (OT2)		Unit: 0.1
Control	VF	VFPG SVC FOCPG TQCPG FOCPM	Factory setting: 0.1
mode
	Settings	0.0 to 60.0 sec

Pr.06-05 and Pr.06-08 determine the operation mode of the drive after the over-torque is detected via the following method: if the output current exceeds the over-torque detection level (Pr.06-06) and also exceeds the Pr.06-07 Over-Torque Detection Time, the fault code “OT1/OT2” is displayed. If a Multi-Functional Output Terminal is to over-torque detection, the

output is on. Please refer to Pr.02-11~02-22 for details. current

								5%	Pr.06-06,
									Pr.06-09
							Pr.06-07, 06-10
06-11		Current Limit								Unit: 1
Control		FOCPG	TQCPG							Factory setting: 150
mode
		Settings		0 to 250%
It is used to set the current limit.
	06 - 12	Electronic Thermal Relay Selection
Control		VF	VFPG		SVC FOCPG TQCPG FOCPM					Factory setting: 2
mode
		Settings	0			Inverter motor

1Standard motor

2Disabled

It is used to prevent self-cooled motor overheats under low speed. User can use electrical thermal relay to limit driver’s output power.

06-13	Electronic Thermal Characteristic		Unit: 0.1
Control	VF	VFPG SVC FOCPG TQCPG FOCPM	Factory setting: 60.0
mode
	Settings	30.0 to 600.0 sec

Revision Nov. 2008, VLE1, SW V1.03 4-65