Delta Electronics VFD-VL manual Step

Chapter 3 Operation and Start Up

Pr.10-02

Encoder Input Type Setting

0:Disable

1:Phase A leads in a forward run command and phase B leads in a reverse run command

2:Phase B leads in a forward run command and phase A leads in a reverse run command

3:Phase A is a pulse input and phase B is a direction input. (low input=reverse direction, high input=forward direction)

4:Phase A is a pulse input and phase B is a direction input. (low input=forward direction, high input=reverse direction)

5:Single-phase input

3.3.2.4 Step 4

Multi-step speed settings

„Please confirm the total speed steps (high speed, middle speed, low speed, creep, inspection and level auto-learning)

„Please make sure that the setting of step speeds and the action of the corresponding terminals of multi-function input commands are correct.

„Setting multi-step speeds in Pr.04-00 to Pr.04-15

	Zero Step Speed Frequency	0.00~120.00Hz
	1st Step Speed Frequency	0.00~120.00Hz
	2nd Step Speed Frequency	0.00~120.00Hz
	3rd Step Speed Frequency	0.00~120.00Hz
	4th Step Speed Frequency	0.00~120.00Hz
	5th Step Speed Frequency	0.00~120.00Hz
	6th Step Speed Frequency	0.00~120.00Hz
Settings of Pr.04-00 to Pr.04-15	7th Step Speed Frequency	0.00~120.00Hz
	8th Step Speed Frequency	0.00~120.00Hz
	9th Step Speed Frequency	0.00~120.00Hz
	10th Step Speed Frequency	0.00~120.00Hz
	11th Step Speed Frequency	0.00~120.00Hz
	12th Step Speed Frequency	0.00~120.00Hz
	13th Step Speed Frequency	0.00~120.00Hz
	14th Step Speed Frequency	0.00~120.00Hz
	15th Step Speed Frequency	0.00~120.00Hz

NOTE: It is recommended to set the max. operating frequency to the half of max. operating frequency before confirming the setting of each step speed and the action of the corresponding terminals of multi-function input commands.

Revision Nov. 2008, VLE1, SW V1.03 3-11