Delta Electronics VFD-VL Motor will run Motor won’t run 10-00=5, Motor will run 10-00=6, 10-01

Chapter 4 Parameters

	Setting of PG		PG signal type	Applicable PG card	Pr.08-00=1	Pr.08-00=3
	signal type
	10-00=4		SIN/COS+Endat	EMVL-PGS01	Motor will run	Motor won’t run
	10-00=5		SIN/COS	EMVL-PGH01/02	Motor will run	Motor will run
	10-00=6		SIN/COS +	EMVL-PGS01	Motor will run	Motor won’t run
			Hiperface
10-01		Encoder Pulse				Unit: 1
Control		VFPG	FOCPG TQCPG FOCPM			Factory Setting: 600
mode
		Settings	1 to 20000

A Pulse Generator (PG) or encoder is used as a sensor that provides a feedback signal of the

motor speed. This parameter defines the number of pulses for each cycle of the PG control.

10-02Encoder Input Type Setting

Control VFPG	FOCPG TQCPG FOCPM		Factory Setting: 0
mode
Settings	0	Disable

1

2

3

4

Phase A leads in a forward run command and phase B leads in a reverse run command

FWDREV

A

For war d running B

Phase B leads in a forward run command and phase A leads in a reverse run command

FWDREV

A For war d running B

Phase A is a pulse input and phase B is a direction input. (low input=reverse direction, high input=forward direction)

FWDREV

A For war d running B

Phase A is a pulse input and phase B is a direction input. (low input=forward direction, high input=reverse direction)

FWDREV

A For war d running B

4-98 Revision Nov. 2008, VLE1, SW V1.03