Delta Electronics VFD-VL Off, Rev, MI1, MI2, MI3, MI4, MI5, MI6, MI7, MI8, Com, Dcm, Mra, Mrc

Terminal symbols and functions				Chapter 2 Installation and Wiring
	Terminal	Terminal Function		Factory Settings (SINK)
	Symbol			ON: Connect to DCM
	FWD	Forward-Stop Command	ON:	RUN in FWD direction
			OFF:	Stop acc. to Stop Method
	REV	Reverse-Stop Command	ON:	RUN in REV direction
			OFF:	Stop acc. to Stop Method
	MI1	Multi-function Input 1
	MI2	Multi-function Input 2
			Refer to Pr.02-01 to Pr.02-08 for programming
	MI3	Multi-function Input 3
			the Multi-function Inputs.
	MI4	Multi-function Input 4	ON: input voltage is 24Vdc (Max. 30Vdc), input
			impedance is 3.75kΩ
	MI5	Multi-function Input 5	OFF: leakage current tolerance is 10μA.
			MI8: when JP1 is inserted, this function is
	MI6	Multi-function Input 6
			disabled.
	MI7	Multi-function Input 7
	MI8	Multi-function Input 8
	COM	Digital Signal Common	Common for digital inputs and used for SINK
			mode
	+E24V	Digital Signal Common	+24V 80mA
		(Source)
	DCM	Digital Signal Common (Sink)	Common for digital inputs and used for SINK
			mode
	RA	Multi-function Relay Output 1	Resistive Load:
		(N.O.) a
			5A(N.O.)/3A(N.C.) 240VAC
	RB	Multi-function Relay Output 1
			5A(N.O.)/3A(N.C.) 24VDC
		(N.C.) b
			Inductive Load:
	RC	Multi-function Relay Common
			1.5A(N.O.)/0.5A(N.C.) 240VAC
			1.5A(N.O.)/0.5A(N.C.) 24VDC
	MRA	Multi-function Relay Output 2
			To output monitor signal, including in operation,
		(N.O.) a
			frequency arrival, overload and etc.
	MRC	Multi-function Relay Common	Refer to Pr.02-11~02-12 for programming
	+10V	Potentiometer Power Supply	-10~+10VDC 20mA (variable resistor 3-5kohm)
	-10V
	MCM	Multi-function Output	Max. 48VDC 50mA
		Common (Photocoupler)

Revision Nov. 2008, VLE1, SW V1.03 2-11