Mitsumi electronic 55K Commercial power supply Inverter switch-over MC1, Fan, Sleep, Abc

				PARAMETERS
Setting		Signal			Related
Positive	Negative		Function	Operation
		Name			parameter
logic	logic
17		MC1	Commercial power supply-
			inverter switch-over MC1
18		MC2	Commercial power supply-	Refer to Pr. 135 to Pr.139 (commercial power	Pr. 135 to
			inverter switch-over MC2	supply-inverter switch-over).	Pr. 139
19		MC3	Commercial power supply-
			inverter switch-over MC3
25	125	FAN	Fan fault output	Output only when a fan fault occurs.	Pr. 244
				Output when the heat sink temperature reaches
26	126	FIN	Fin overheat pre-alarm	about 85% of the fin overheat protection	
				temperature.
40		SLEEP	Output at stop
41		R01	Commercial power supply side
			motor 1 connection R01
42		R02	Commercial power supply side
			motor 2 connection R02
43		R03	Commercial power supply side
			motor 3 connection R03
				Refer to Pr. 500 to Pr. 516 (advanced PID
44		R04	Commercial power supply side
				control). (Page 145)	Pr. 500 to
			motor 4 connection R04	(Setting may be made for the NA and EC versions	Pr. 516
			Inverter side motor 1
45		RI01		only.)
			connection RI01
46		RI02	Inverter side motor 2
			connection RI02
47		RI03	Inverter side motor 3
			connection RI03
48		RI04	Inverter side motor 4
			connection RI04
98	198	LF	Minor fault output	Output when a light fault (fan fault or	Pr. 121, Pr. 244
				communication error alarm) occurs.
99	199	ABC	Alarm output	Output when the inverter's protective function is	
				activated to stop the output (major fault).
9999			No function		
0 to 99:	Positive logic
100 to 199: Negative logic

Note: 1. When the frequency setting is varied with the analog signal or the key of the operation panel, note that the output of the SU (up-to-frequency) signal may alternate between ON and OFF due to that varying speed and the timing of the varying speed dependent on the acceleration/deceleration time setting.

(Such alternation will not take place when the acceleration/deceleration time setting is "0 s".)

2.The same function may be set to more than one terminal.

3.When the function is activated, the terminal conducts with the settings of 0 to 99 and does not conduct with the settings of 100 to 199.

4.Pr. 190 to Pr. 195 do not function if the values set are other than the above.

5.When Pr. 76 = 1 or 3, the output signals of the SU, IPF, OL and FU output terminals conform to Pr. 76. When an inverter alarm occurs, the signal outputs are switched over to alarm code outputs.

6.The output assignment of the RUN terminal and alarm output relay conforms to the above setting independently of Pr. 76.

4

141