Mitsumi electronic 55K, FR-F520-0.75K instruction manual How to use terminals STOP, CS and PC

INSTALLATION AND WIRING

5)Source logic type

•In this logic, a signal switches on when a current flows into the corresponding signal input terminal. Terminal PC is common to the contact input signals. Terminal SE is common to the open collector output signals.

PC	Current flow related to
	RUN signal

Inverter AX80

Current	STF
	STR	R
		R

RUN

SE

24VDC

1

R

R

9

•When using an external power supply for transistor output, use terminal SD as a common to prevent misoperation caused by undesirable current.

AY-80			Inverter
		PC
9
1		STF	DC24V
			(SD)
2		STR
10	DC24V	SD

(4) How to use terminals "STOP", "CS" and "PC"

1)Using the "STOP" terminal

A connection example (for sink logic) for self-holding the start signal (forward rotation, reverse rotation) is shown on the right.

2)Using the "CS" terminal

This terminal is used to perform automatic restart after instantaneous power failure and commercial power supply-inverter switch-over operation.

<Example: Automatic restart after instantaneous power failure in sink logic>

Connect terminals CS-SD and set a value other than "9999" in Pr. 57 "coasting time for automatic restart after instantaneous power failure".

	STOP
	MRS
	Stop
	RES
Forward	SD
rotation	STF
Reverse
rotation	STR

CS SD

(Short)

3)Using the "PC" terminal

This terminal can be used as 24VDC-power output using SD as a common terminal. Specifications: 18V to 26VDC, 0.1A permissible currents

Note that the wiring length should be within 30m (98.43feet). Do not short terminals PC-SD.

When terminal PC is used as a 24V power supply, leakage current from transistor output cannot be prevented.

21